Note! Ubåten has detected a virus on their USB drives. We are unsure whether MAKE has been affected, but in the meantime we recommend not running or opening any unknown files.
Dual-colour calicat
You are viewing an old event. The last occurrence of this event was 02/27/2026

Raise3D printer course

REQUIRES TAKING "COURSE IN 3D-PRINTING" BEFOREHAND

This course requires that you have taken the beginner course in 3D printing before signing up. This course assumes that you have general knowledge and experience with the use of 3D printers. Completed course gives access to the Raise3D printers.

 

Course content:

- Rules 

- Different materials and print settings

- A little bit about dual extrusion and multicolour prints

- Intro to Ideamaker and how to setup the slicer

- Practical aspects when using the Raise3D Pro2 / Pro2 Plus printers 

- Final quiz to test your knowledge

 

Link to presentation (Norwegian)

You are viewing an old event. The last occurrence of this event was 02/27/2026